In this video, I will show you how to install the S10&S30 Series X+Y Expansion Kit. It is a Step By Step Instructions. Easy-to-follow tutorial!
(Please open the video subtitles and use automatic translation.)
⭐️IMPORTANT⭐️
Upgrading requires tweaking motherboard power output intensity (05:08)
When pushing the extension gantry, push it from the middle
When assembling, note that there should be three screw holes on the left inner front side to install the limit switch (11:54)
After adjusting the size of the working range, you need to write $130=900 and $131=920 to the mainboard respectively, otherwise the limit switch may be abnormal (19:29)
If the gantry is not running smoothly, it is necessary to adjust the balance of the eccentric nuts on both sides. If the belt is completely fitted to the edge of the gear, it is recommended to adjust the gear position (13:54)
Early products may lack four M5*12 fixing screws and an S10 adapter board. If necessary, please contact customer service to reissue
In the follow-up package, additionally add the cable holder*12 and the cable tie*10 to organize the cables
🤩Do you want to have a laser engraving machine with an engraving area up to 900x920mm?
Purchase links here👇👇👇 (Only for Sculpfun S10 & S30 Series)